Did you do the 21-step specification operation of the automatic blow molding machine?
1 Lubricate the moving parts once before each shift. (manipulator, manipulator guide, open and close die guide)
2 The swing arm can be added once every (3 – 4) days. The heating chain has a large chain and a small chain once a month. Always check if the main unit reducer and the warmer reducer are short of oil. The main bearing can be added once every 3 months.
3 Check whether the moving parts are firm before production, and whether the ydskyhht screws are loose or not, especially in places with strong impact, whether the belt transmission parts are abnormal.
4 Check if the high pressure gas source, low pressure gas source, power source and water source are normal.
5 Check each emergency stop switch, safety door switch, and protection device to check if the switch is normal.
6 Check the warming head to enter the embryo, and the part of the embryo is working properly. If the insert is not in place, the nut of the preform can be adjusted.
7 Check the lamp for damage and breakage. Replace it in time.
8 Check if the pneumatic components are leaking and the action is sensitive.
9 Check if the triplet is abnormally leaking, blocked, and the water storage capacity of the cup is too full.
10 When the solenoid valve of the automatic blow molding machine encounters an abnormality, it should be cleaned in time (cleaning 3.5 million per blow bottle).
11 Blowing molds must be cleaned and polished regularly.
12 When the high and low pressure air supply switch is turned on, it must be operated slowly to prevent the air flow rate from being too fast. The dirt is blown into the solenoid valve, and the exhaust valve is opened for 30 seconds to ensure the air is clean.
13 The automatic blow molding machine must be sure that the mechanical part is good when starting, there is no inside of the machine, no foreign matter. In particular, shake the position to avoid hurting people. Also close the security door.
14 When starting the machine, the motor must be started first, and the warmer should be started for 30 seconds to prevent voltage fluctuations. Before starting the warming, ydsky1221 determines whether the cooling water has been turned on.
15 After warming up (2—3) minutes, the oven temperature rises evenly, and the embryo button is pressed. At the same time, the blowing bottle should be turned on, otherwise it will not blow.
16 When the automatic blow molding machine is running, it is necessary to pay close attention to whether the machine has abnormal noise. It is necessary to find early and solve the problem in time.
17 In case of emergency, press the emergency stop button to brake urgently. Then, according to the situation of the situation analysis, find the problem and solve the problem quickly.
18 After the automatic blow molding machine is in normal operation, do not put any part of the body into the machine to avoid injury to the robot. If the machine has abnormal noise, it can be observed after deceleration.
19 After the automatic blow molding machine is in normal production, the operator must always observe the quality of the bottle to avoid voltage fluctuations or other reasons affecting the quality of the blowing bottle.
20 When the automatic blow molding machine is being repaired, press the touch screen fault repair button to ensure safe maintenance. If you need to manually observe the movement of each cavity separately, please pay attention to the position of the robot. At the same time, be sure to understand the role of the individual buttons to ensure that the malfunction caused unnecessary trouble.
21 After the automatic blow molding machine is finished, be sure to clean tools and screws, etc., so as not to remain in the machine and affect the normal operation of the machine.